If you look at this difference, you'll understand why Japanese windows are no good.
If you look at this difference, you'll understand why Japanese windows are no good.
In Europe, when designing a window, it is of course necessary to calculate the thermal transmittance of the entire window.
The design is based on the assumption that the temperature at the lowest point of the window will be very high.
This is because condensation is most likely to occur on the coldest surface areas.
In Europe, there are many different types of sashes, including resin, wood, and aluminum.
The minimum standard for the thermal transmittance of windows, whether they are for residential or commercial use, is around 1.
(Almost five times the performance of the best-selling product in Japan, and three times the performance of the standard of major housing manufacturers.)
So this point is strictly observed regardless of the type of sash.
However, this is not possible with Japanese sashes. A simulation that clearly shows this
I would like to show you an image. By the way, this is a simulation with a room temperature of 20℃ and an outside temperature of 0℃.
Furthermore, if the relative humidity is 50% under these temperature conditions, condensation will occur in any area below 10°C.
From top to bottom, L's flagship product "Sir XXX"
Y Company's flagship product "Axxxxxx"
This aluminum sash complies with current EU standards.
The top represents the exterior side and the bottom represents the interior side.



What do you think of this? The two domestically produced sashes are said to be the highest spec windows in Japan, and their adoption rate in new buildings is definitely below 5%. Even so, you can see that the temperature around the joint between the glass and the frame is considerably lower.
In contrast, EU windows have almost no blue tint.
This is why Japanese windows get condensation.
The contractors will give you various excuses, but sometimes condensation on windows is caused by humidifiers, etc.
It does happen, but in most cases it's simply due to poor window performance and flawed design techniques.
Japanese home improvement manufacturers have produced toilets that make noise even when not requested, and kitchens with electronically opening drawers.
We are increasingly coming out with products like these.
On the other hand, condensation, which has the third highest rate of dissatisfaction after moving in, continues to be ignored.
(First place was hot, and second place was cold, which were almost tied for first place. In the end, windows were the biggest factor.)
As we mentioned before, condensation means your windows are acting as dehumidifiers.
I use a humidifier to humidify while dehumidifying through the window. That's a terrible thing to do, but there are other things too.
It also induces mold. If you leave this area, you will waste your precious budget on things like a noisy toilet.
I'm really sad that it will be washed away.
To all construction companies and design offices, please never allocate your budget like this from tomorrow onwards!!















