1. HOME
  2. Blog
  3. "Kazuya Matsuo's Eco House Design Method" is featured in the October issue of Shinken Housing PLUS 1.

"Kazuya Matsuo's Eco House Design Method" is featured in the October issue of Shinken Housing PLUS 1.

"Kazuya Matsuo's Eco House Design Method" is featured in the October issue of Shinken Housing PLUS 1.

Shinken Housing Custom-built homes in Kobe City

It is serialized every two months, and this month's issue arrived today.

This article is the latest version of how to select the capacity of an air conditioner.

Due to copyright issues, only two pages out of four are available.
The resolution has been reduced to the point where it is just barely noticeable.

Shinken Housing Custom-built homes in Kobe City

In the past, I have written about the formula for calculating capacity from heating in architectural knowledge.
Calculating the heating capacity was pretty easy, but if you include cooling...
"If the building is properly shaded from the sun, the heating calculations will be fine."
I summarized it with the following conclusion.

I have never actually run out of space in the houses I design.
Once again, we will consider how to calculate the capacity from the perspective of cooling according to the performance and design of various houses.
I thought about it.

I believe this is a very simple and effective calculation method.

After writing this article, I feel like I have gained more knowledge about air conditioners.

To sum up, a Q value of 1.9 to 2.7 is sufficient for proper solar shading.
If the building is one that has been approved, the selection will be made according to the formula we previously mentioned.
I don't think there's any problem.

However, if the Q value is below 1.9 or if the solar shading is not adequate,
In buildings where this is not possible, the capacity selection based on heating calculations can be significantly
There is a shortage.

In particular, in the case of buildings where the Q value is abnormally high and solar radiation shading is not possible, the heating load calculation
We found that it may be necessary to have 10 times the capacity required for the results.
(I don't think there are many people who would design a house like that.)

I believe this is a quick reference guide that has never been found anywhere else, so I hope that practitioners will take a look at it.
think.

Related article

Book introduction
Past articles